Tow Dolly: Drawbar Latch & Angle Stops


Click to Enlarge

With the top deck mounted on the sub chassis and with the drawbar fitted, the angle stops can be fitted to the top deck. Rotate the top deck 8 degrees in both directions and clamp and weld the stops in position.

Note - when welding on the trailer, keep the earth clamp attached as close to the weld area as possible. Do not let the earth track through the permaglide bearing.


Source a good quality spring latch and fit to the drawbar. Be sure to allow clearance between the tilt shroud and the spring latch pin and body when tilting.

If required, weld a packer plate onto the tilt shroud to remove any gap between the shroud and the latch pin.